Resetting Powermax Installer Code For Silent. All rights reserved. No part of this site can be reproduced in any form or by any means, electronic, mechanical, photocopying, or otherwise, without the prior written permission of Mega Controls Inc. Hiren's Boot. Another handy tool to backup drivers. Nov 20, 2013. Power up with these shorted and the time and codes will reset with everything else intact. So power up with E and F shorted, disarm using 1111 goto installer and enter 9999. Short D & E and everything gets wiped? Short E & F and just codes get wiped? Altor's Avatar. Altor Registered User.

• Powermax Reset Install Code

Occasionally the software in the control panel may become corrupted or you may simply have got lost in the programming and changed something you didn’t intend to.

The control panel is supplied with a Non-Volatile memory (NVM) which is loaded with a set of factory defaults. The control panel can be reset to its factory defaults in two ways – a Soft-Reset and a Hard-Reset.

If the panel is not behaving as you expect then you should first perform a Soft-Reset. If the problems are not cured then you should try a Hard-Reset.

The control panel default values are shown in the installation manual by ‘greyed out squares’ next to the available options.

Jessica Steele is a nasty lil' slut who is about to get impaled by a gigantic cock in her first boy/girl scene ever! Might and magic heroes 6 shades of darkness crack download.

The soft-reset procedure is described in the installation manual, the hard-reset isn’t.

Soft Reset

A Soft-Reset will not reset the master installer code or user code. A soft-reset will reset the zone programming etc. All devices will be deleted.

To perform the Reset:

1. Enter Installer Mode.
2. Scroll through the menus until you see FACTORY DEFLT, Press <OK>.
3. Display will show <OK> to restore, Press <OK>.
4. Display will show ENTER CODE, enter the master installer code.
5. Display will show PLEASE WAIT.. for a short time, after which the factory defaults will have loaded.
6. The display will revert to FACTORY DEFLT.

Hard-Reset

A Hard-Reset will reset the Master installer code to 9999 and the user code to 1111.

To perform a hard-reset on the Powermax Pro control panel;

1. Remove the mains power to the control panel.
2. Open the control panel and disconnect the battery.
3. Identify the 3 pins marked DEF
4. Fit a jumper across the D and E pins
5. Apply battery power to the panel for approximately 10 seconds.
6. Remove battery power from the panel.
7. Remove the jumper from the D and E pins.
8. Re-connect the battery.
9. Close the panel and apply mains power.

Powermax Reset Install Code

The procedure for the Powermax plus uses the RST pins instead of the DEF pins.